Comments for Eagle Equipment's Blog

Comment on New Product! GLO-970 – Center Mount Tire Changer with Lift by tyres in Redditch

tyres in Redditch — Sun, 10 Apr 2011 01:21:08 +0000

Yet, even among manual motorcycle tire changers, there are differences that motorcycle owners need to be aware of. For example, cheaper motorcycle changers can damage painted alloy rims, due to the way they work. You can try to lessen the chance of getting your rims damaged by holding the clams with duct tape, but this may be annoying after a while.

Comment on Tips for Buying an Automotive Car Lift by cml

cml — Fri, 18 Mar 2011 03:27:49 +0000

Any motorist will know that, no matter how much money you pay for a car, how new or old it is, there will always be something that can go wrong. It doesn’t matter how rare the fault is, or how well the car runs most of the time

Comment on Car Lifts in In Stock – Buy NOW before Prices Increase by cml

cml — Fri, 18 Mar 2011 03:25:41 +0000

well
i like it

Comment on Proper Lift Installation—Floor Requirements and Preparation by coriag

coriag — Tue, 18 Jan 2011 14:46:03 +0000

Nice post, and it so informative, I learned a lot from this article. keep it up.

Comment on Proper Lift Installation—Floor Requirements and Preparation by eagleequip

eagleequip — Fri, 19 Nov 2010 05:27:46 +0000

I apologize for not responding sooner but I have forwarded your question to one of our specialists. They should be responding to your inquiry by email within the next day or so.

Comment on Proper Lift Installation—Floor Requirements and Preparation by richard rennie

richard rennie — Thu, 28 Oct 2010 23:35:27 +0000

my floor im my garage is not very good for a lift.how much of a area would need to be removed and repoured in order to support a 2 post lift requireing a 4inch thick pad?

Comment on Proper Lift Installation—Floor Requirements and Preparation by eagleequip

eagleequip — Thu, 09 Sep 2010 16:43:42 +0000

FLOOR REQUIREMENTS

Specifications of concrete must be adhered to. Failure to do so could cause lift failure resulting in personal injury or death.

A level floor is suggested for proper installation and level lifting. Small differences in floor slopes may be compensated for by proper shimming. If a floor is of questionable slope, consider a survey of the site and/or the possibility of pouring a new level concrete slab.

-DO NOT install this lift on any asphalt surface or any surface other than concrete.
-DO NOT install this lift on expansion seams or on cracked or defective concrete.
-DO NOT install this lift on a second/elevated floor without first consulting building architect.
-DO NOT install this lift outdoors unless special consideration has been made to protect the power unit from inclement weather conditions.

CONCRETE SPECIFICATIONS
Lift Model – 9K/10K
Concrete Requirement – 4″ Minimum Thickness

NOTE: All models MUST be installed on 3,000 PSI reinforced concrete only; conforming to the minimum requirements shown above. New concrete must be adequately cured for at least 30 days.

Comment on Proper Lift Installation—Floor Requirements and Preparation by Vincent Radosevich

Vincent Radosevich — Fri, 03 Sep 2010 23:07:42 +0000

What are the rebar requirements for the concrete? I am installing a two post lift, 10000lb max capacity.

Comment on Customer Feedback by eagleequip

eagleequip — Wed, 02 Jun 2010 13:47:56 +0000

Thanks Mike! I forwarded your previous message several weeks ago and I am glad they were able to find a solution for you.

Comment on Customer Feedback by mike

mike — Wed, 12 May 2010 20:03:59 +0000

Hello
Back in March I contacted the company about a problem I had with a lift I purchased. I contacted the service dept and did not get any response to my problem. Since then Eagle Equipment has come through and fixed the problem and I am greatfull for there effort. Eagle Equipment is ACES in my book. I will be looking to Eagle Equipment for further purchases in the future. They stand behind
there products.
Sincerely Mike